Cool concrete: It’s not dull, grey and boring any more — concrete with colour has that wow factor
Joanne Blain
Sun
An understated, burnished look in a contemporary residence, above, and a more colourful treatment, below, both created with Colormakers concrete products.
Gary Jones of Smart Surface Technology in a house in the Main Street corridor that had its rough concrete floor replaced with a polished, warm beige one.
One or more colours can be combined to create a wide variety of colours and effects — and homeowners can even apply the dyes or stains themselves.
Get over the idea that concrete floors belong only in the garage or the laundry room. With a shot of colour and a polished sheen of a finish, they can work in any room of the house.
Just ask Gary Jones. The Richmond-based president of Smart Surface Technology was brought in to finish the concrete floors that run from top to bottom of a $20-million San Francisco house.
Think Yaletown loft rather than sidewalk and you’re on the right track. The type of floors Jones’s company creates are smooth, burnished canvases of colour, without a square inch of dull grey concrete in sight.
Growing numbers of homeowners are noticing decorative concrete floors in commercial buildings and realizing they may be the answer to their quest for a practical, contemporary-looking floor.
The wow factor is also a big draw, Jones says.
“A lot of people want concrete because they want to be unique,” he says. “They don’t want to be like the guy down the road — they want something cool.”
And Jones has lots of ways to achieve that look. Under the Colormakers label, his company markets both stains and dyes that can be used to colour an existing concrete floor, as well as colour-enhanced resurfacing treatments.
All three types of products are water-based and sink right into the concrete rather than sitting on top of it like paint, which tends to chip and flake over the years, he says.
Colormakers has eight shades of stains, which are spread over an existing concrete floor and create an irregular pattern of colour by reacting with the lime in the concrete. These generally produce earth tones like copper and bronze, Jones says.
Water-based dyes come in 25 shades, many of them vivid, and are sprayed on top of the concrete for a translucent effect.
Colormakers also makes resurfacing treatments — essentially a thin coating of concrete, pre-coloured in eight shades — that can go right over ceramic tile or concrete that’s irregular or in poor condition.
That was the situation in a house in the Main Street corridor with rough, uneven concrete floors. The homeowner chose a resurfacing treatment in a warm beige colour to smooth out the floor and add a up-to-date look to the fairly conventional home.
Even though the floor is in a below-grade basement, it’s warm to the touch. When properly insulated from below, Jones says, concrete floors absorb the ambient temperature of the room, making them far more comfortable underfoot than unheated ceramic tile.
Concrete also breathes, he says, meaning that it doesn’t trap moisture and become musty like carpets often do when installed in basements.
As well, if you get bored with the look of your floor, it’s relatively easy process to change it.
“If in five years you want to change the colour of the floor, we can do that,” Jones says — just remove the sealer, apply a new colour and re-seal it.
And you’re not restricted to just a stain, a dye or a resurfacing treatment — you can combine one or more to create a wide variety of colours and effects. “You end up with a thousand combinations if you really play around with it,” says Jones.
You can also vary the intensity of the surface sheen by putting down just a couple of layers of finish or a dozen, he says. And maintenance is easy — clean up spills quickly and then every year or two, mop on a liquid wax “to give it a nice sheen again.”
Jones says he’s seen decorative concrete floors that are 14 or 15 years old and still look great. “You can’t really degrade one of these surfaces if it’s put down right.”
And it doesn’t take a huge amount of expertise — homeowners can apply the dyes and stains on existing concrete themselves for as little as 50 cents a square foot, says Jones. If they’re ambitious, they can even put down a resurfacing treatment for about $1.50 a square foot, he says. Hiring a contractor will bring the cost up to between $4 and $6 a square foot, depending on the treatment.
About 70 per cent of Jones’ customers in the U.S. and Canada are commercial, including retailers like Whole Foods, Starbucks and Bootlegger. But the residential market for decorative concrete is growing, he says.
“Many homeowners have seen it in a restaurant or store and they want that floor,” he says. And seeing finished concrete on the floor of a high-traffic business “tells you that it can take a lot of wear and tear.”
Smart Surface Technology is offering half-day workshops at their Richmond headquarters for do-it-yourselfers who want to learn how to stain or dye existing concrete floors and how to apply a coloured concrete overlay to an existing floor. The workshops run every Saturday starting Nov. 25 and cost $75 (discounts for groups available). For more information, call 604-244-3122. The Colormakers product website is www.colormakerfloors.com.
© The Vancouver Sun 2006
For more information on lofts check out our Vancouver Lofts website.
For more information on Yaletown’s lofts check out our Yaletown Lofts website.